Build a bongggg

 How about a bong?

You need:

• A plastic coke bottle
• A small piece of piping – 5/10cm
• A socket from a socket set that will fit in the end of the pipe
• A knife

Instructions

1. Make a hole for the pipe about 1/3 way up bottle and insert pipe so pipe is bending down into the bottle.
2. Put the socket in the end of the pipe outside the bottle
3. Make a smaller hole in the bottle above the first hole
4. Fill bottle with water so that pipe is in water, but water level does not reach the hole.

      Ok. The socket is where you put your mix(tobacco and your crumbled solid) and the second hole acts as an air-hole. When you have filled the socket with your mix, you light the mix and suck through the bottle top while holding your finger over the air-hole.
To clear the bottle, either suck all the smoke out or take your finger off the air-hole and blow the smoke out. So there you have it, a simple bong.

Now Gravity bongg

Okay first thing is first. Supply's!

1. A sink/tub/5 gallon bucket.

2. A 2 or 3 liter bottle (empty).

3. A knife.

4. Lighter.

5. Metel pipe bowl.

6. Pot. 

Okay now that you have all the supplys lets get started! Rip off the label on that bottle. Than take that knife and cut off the bottom of your bottle right above the feet of it. Unscrew the cap and take the knife and pop out the little plastic part on the inside of the cap. Than take your lighter and heat up/soften the middle of the cap. You'll need patience for this. Because this is where you metal bowl piece is going. So you need to make sure it fits snug and doesn't leak air. Once it's melted to about the size you need you can go ahead and screw in the bowl peice to the cap. Put some weed in the bowl. Put the bottle in the water with the mouth of the bottle barely sticking out of the bottle. Screw on the cap. Light the weed. pull up slowly, unscrew, and inhale. :)